What to do before we arrive
Every minute of spraying water adds to the damage. These steps come before anything else.
- Close the house shutoff. Usually where the supply line enters the house, often near the front hose bib.
- Kill power near the water. Switch off breakers for any outlets or appliances in the wet area if you can reach the panel safely.
- Open a low faucet. An outdoor hose bib drains pressure out of the lines.
- Move valuables and take photos. Document the damage before cleanup, for insurance.
If the house valve will not close, the curb valve in the meter box belongs to the water utility. In an emergency, call Mesa Water or IRWD, or tell us and we will talk you through it.
Why pipes burst in a mild climate
Freezing is rare here. These are the usual causes behind a Costa Mesa burst.
| Cause | Where it shows up | What we fix |
|---|---|---|
| Corroded galvanized pipe | Older homes, often in walls and under sinks. | Replace the section, check the rest. |
| Pinhole in copper | Hot lines in slabs and walls. | Replace the section or reroute. |
| Failed supply connector | Toilets, faucets, washers, icemakers. | Replace with braided steel connectors. |
| High water pressure | Anywhere, often several failures at once. | Replace or add a reducing valve. |
| Earthquake movement | Rigid connections at water heaters and appliances. | Flexible connectors and bracing. |
Check the pressure, or it will happen again
The California Plumbing Code, which is based on the Uniform Plumbing Code (UPC), requires a pressure reducing valve when incoming pressure is above 80 psi. Reducing valves wear out over time, and when one fails, pressure in the house climbs to street pressure.
We put a gauge on a hose bib on every burst call. If pressure is high, fixing the pipe without fixing the valve just moves the next failure somewhere else.
Repeated bursts in an older home usually mean the pipe itself is done. A full repipe replaces it all at once instead of one emergency at a time.
Washing machine hoses are a common burst point. Braided steel hoses, replaced every five years or so, are cheap insurance.
Condos and shared walls
In a condo or townhome, a burst line may sit inside a shared wall or feed from a common riser. The unit shutoff may not stop it, and the association may control the building valve.
Call the HOA's emergency number at the same time you call us. Tell us the building and unit, and whether water is reaching a neighbor. Who pays usually depends on whether the failed pipe served only your unit, which is something our repair notes can document for the association.
After the leak stops: drying out
Fixing the pipe does not dry the wall or subfloor behind it. Wet drywall, insulation and cabinets need proper drying to avoid mold.
Water damage cleanup and water mitigation are handled by a separate dedicated line, listed on those pages. Call them once the water is off.
Burst supply lines are most likely in the 1950s and 1960s homes of the Eastside, the Westside and College Park, where copper and galvanized pipe has decades of wear, and at worn supply connectors in the condos around South Coast Metro and Wimbledon Village.
Cracked fittings, split elbows and pinhole leaks
Not every burst is a dramatic split. Many are a cracked elbow with water flowing out of it, a PVC connector leaking under the house, or a pinhole in a half-inch copper line that sprays a fine mist inside a wall. Small leaks like these still soak framing and drywall fast.
Copper pinholes are worth reading. One can be repaired with a short new section. Several within a year usually mean the pipe is thinning from the inside, and repiping becomes the cheaper path.
Old galvanized lines fail at the threads, where the wall of the pipe is thinnest. If one galvanized section has burst, the rest of that line is usually close behind.
When it is the valve, not the pipe
A supply valve can fail as badly as a pipe. The stop valve behind a toilet or under a sink, the valves behind a washing machine, or the line to a refrigerator ice maker can break and send a lot of water out of the wall with no way to close it there.
Do not force a broken valve. Close the main shutoff, then call. We replace the failed valve and check the other old valves in the house, because they went in at the same time and wear the same way.
What burst pipe repair costs
The pipe repair is usually modest. Access and the time of day move the number most.
| Factor | Why it matters |
|---|---|
| Location | A pipe under a sink costs less to reach than one inside a finished wall or ceiling. |
| Pipe material | Galvanized-to-copper or PEX transitions need extra fittings. |
| Pressure valve | Replacing a failed reducing valve adds parts and labor. |
| Wall or ceiling opening | Opening and closing drywall adds time. Finish work is separate. |
| Timing | Night, weekend and holiday calls cost more than daytime visits. |
Insurance note: a policy that pays for soaked drywall and flooring may still refuse the cost of the pipe itself. Photos and our repair invoice help the claim.
Want your real number? Call (714) 750-8637 and describe the job.
Emergency response near you
We respond to burst pipes across 92626 and 92627 and in nearby cities like Newport Beach. If the water is coming from somewhere you cannot see, a leak test finds it.