The meter keeps moving but you cannot see water anywhere
These are the signs that send most people to a leak test. Any one of them is worth checking.
- The water bill jumped and nobody in the house changed their habits.
- The small leak indicator on the meter spins with every tap, toilet and sprinkler off.
- A warm spot on a tile or concrete floor, often near the kitchen or a bathroom.
- The sound of running water inside a wall when nothing is on.
- Damp drywall, lifting baseboards, or a musty smell in one closet or corner.
- A patch of lawn that stays green and soft when the rest of the yard is dry.
Emergency leak detection: when it cannot wait until morning
Most hidden leaks are slow, and a test the next morning is fine. Some are not. If the meter dial spins fast with every fixture off, if you can hear water running inside a wall or under the floor, or if water is coming through a ceiling, treat it as an emergency.
Close the main shutoff first. That stops the damage and turns a flood into a detection job. Then call our 24/7 line and say what you heard and where, because that decides which equipment comes on the truck.
When the source is reachable, we can often find it and repair it on the same visit. When it sits under a slab or a driveway, we mark the spot, explain the options and, where that line can be isolated, get the rest of the house back on water.
Check your own meter in ten minutes
Before you call anyone, this simple test tells you whether a leak exists and roughly where it is.
- Turn everything off. Close every faucet and shower, stop the washer, dishwasher and sprinklers, and make sure no toilet is refilling.
- Read the indicator. Open the meter box at the curb and watch the small triangle or dial on the meter face for two minutes.
- Close the house valve. Shut the main valve where the line enters your house and watch the meter again.
- Read the result. If the indicator stops, the leak is inside the house. If it keeps turning, the leak is in the line between the meter and the house or in the irrigation system.
Write down what you saw. It saves time on the call and helps us bring the right equipment.
If the bill is what tipped you off, our high-bill check covers the usual causes, and a stain on drywall is covered under ceiling and wall leaks.
Where hidden leaks show up in Costa Mesa homes
The type of home changes where we look first.
| Home type | Where leaks hide | What we use |
|---|---|---|
| 1950s and 1960s single-story ranch | Copper or galvanized lines under the slab and in exterior walls. | Acoustic listening and thermal imaging on the slab. |
| Homes with yards and sprinklers | The service line from the meter and irrigation valves. | Meter isolation and ground microphones. |
| Condos and townhomes | Shared walls and the unit above, or a common supply riser. | Moisture mapping and pressure tests by zone. |
| Homes with a pool or spa | Return lines and the equipment pad. | Pressure testing of each line. |
If the test points under the slab, the next step is slab leak work, where we compare a spot repair with rerouting the line. For a pool, see pool line testing.
How we pinpoint the leak
We start by splitting the plumbing into zones. Closing valves one at a time and watching the meter tells us whether the loss is in the service line, the hot side, the cold side or irrigation.
Then we narrow it down. Ground and floor microphones pick up the hiss of water escaping a pressurized pipe. A thermal camera shows the warm trail of a hot water leak through a slab or wall. On quiet or very slow leaks, a harmless tracer gas pushed into the line rises through the ground or floor, and a sensor finds it.
Pressure testing works the same way inspectors accept new supply piping under the California Plumbing Code, which is based on the Uniform Plumbing Code (UPC). A section is isolated, pressurized and watched on a gauge. If the gauge drops, the leak is in that section.
When the spot is confirmed, we mark it and walk you through the repair options before anything is cut.
Hot water leaks under a slab are often easier to find than cold ones. The heat shows up on the thermal camera even when the floor looks dry.
Who owns the leaking pipe
The meter and everything on the street side belong to your water utility. Most of Costa Mesa is served by Mesa Water District, and some addresses by the Irvine Ranch Water District. A leak in the meter box itself or the street is theirs to fix, so call them first if water is bubbling up at the curb.
On the house side of the meter, the pipes are usually the property owner's. Confirm the exact handoff point with your utility, since each agency sets its own rules.
Leak detection for businesses and rentals
Commercial spaces and multi-unit buildings add complications. Supply lines serve several units or restrooms, fixtures cannot always be shut off during business hours, and the leak may be in a ceiling above an occupied space.
We isolate the building by zone, test after hours when water can be shut down, and give the owner or property manager written findings. That record matters when a tenant, a neighbor and an insurer all need the same answer about where the water came from.
Slab homes are everywhere in Costa Mesa, from the Mesa Verde tracts west of Harbor Boulevard to the Eastside streets that run toward the Back Bay, and that is where non-invasive testing saves the most floor.
What happens after the leak is found
| Where the leak is | Usual next step | Covered on |
|---|---|---|
| Under the slab | Spot repair, reroute or repipe. | Slab leak repair. |
| In a wall | Open a small section, repair, patch. | This page and burst pipe repair. |
| Meter to house | Repair or replace the service line. | Water line repair. |
| Irrigation | Repair the line or valve. | Hose bib and outdoor repair. |
| Pool or spa | Seal the fitting or repair the line. | Pool leak detection. |
The detection visit ends with the leak marked and the options priced, so you choose the fix with the facts in hand.
Raised floors and leaks under the house
Not every home sits on a slab. A raised floor with a crawl space shows up in some older houses and room additions, and leaks there behave differently. People describe it as the sound of a shower running under the house, or a damp, musty smell in one room.
Under a raised floor the pipe is usually visible once we are in the crawl space, so finding the leak is faster than under concrete. The risk is what you cannot see from inside: soaked insulation, wet framing and standing water that feeds mold.
If you hear water under the floor, close the main and keep people out of the crawl space until power to any wet area is off. A drain leak under a toilet or tub is as common as a supply leak, and the fix is different, so we check both.
What leak detection costs
Finding a leak is priced separately from fixing it. These factors set the detection price.
| Factor | Why it matters |
|---|---|
| Number of lines | A single suspect line tests faster than a whole house with irrigation and a pool. |
| Leak location | Slab and underground leaks take more equipment time than a wall behind a sink. |
| Leak speed | Very slow leaks may need tracer gas instead of acoustic listening. |
| Access | Furniture, flooring and finished ceilings affect how much we can test from the surface. |
| Time of day | An active leak after hours costs more than a scheduled daytime test. |
Insurance note: many homeowner policies pay for water damage from a sudden leak and sometimes for access to reach it, but not for the worn pipe itself. Keep the detection report, since insurers often ask for it.
Want your real number? Call (714) 750-8637 and describe the job.
Leak testing near you
We test homes, condos and small commercial spaces across 92626 and 92627 and in nearby cities like Westminster. If the leak turns out to be a failing tank, a water heater replacement is the fix. If the old pipes keep failing in different spots, a repipe is worth pricing.