What the symptom usually means
A few questions on the phone narrow down the part before we arrive.
| What you notice | Likely cause | Usually repairable? |
|---|---|---|
| Gas tank, no hot water, pilot out. | Thermocouple, flame sensor or gas valve. | Yes, in most cases. |
| Electric tank, lukewarm water. | One failed element or thermostat. | Yes. |
| Water dripping from a pipe on the side. | Relief valve opening, often from high pressure. | Yes. |
| Puddle under the drain valve. | Worn drain valve. | Yes. |
| Water seeping from the tank body. | Corroded tank. | No. The tank needs replacing. |
| Rotten egg smell from hot water only. | Reaction at the anode rod. | Often, with an anode swap. |
If water is pooling right now, our leaking water heater service walks through the first steps. A seeping tank body cannot be patched, whatever its age. Water heater replacement is the next step, and planned swaps get a free estimate.
A dripping relief valve is a warning, not just a leak
The temperature and pressure relief valve opens when pressure or temperature inside the tank climbs too high. If it drips, the valve may be worn, or it may be doing its job because pressure is too high.
The California Plumbing Code, which is based on the Uniform Plumbing Code (UPC), calls for a pressure reducing valve when street pressure is over 80 psi. Homes with a reducing valve or a check valve also need an expansion tank, because heated water has nowhere to go. We test the pressure before replacing the relief valve, so the new one does not start dripping next week.
Never cap or plug a dripping relief valve. It is the part that keeps a tank from failing violently.
No hot water emergency? Safe checks before you call
These take a few minutes and sometimes solve the problem outright.
- Electric tank: check the breaker. If it tripped, reset it once. If it trips again, leave it off.
- Gas tank: look through the sight glass for the pilot flame. Relight only by following the label on the tank.
- Smell gas at any point: stop, leave the garage, and call SoCalGas at 1-800-427-2200.
- Leak at the base: close the cold-water valve on top and turn the gas control to OFF.
Local water and what wears out first
Mesa Water's 2025 report lists 2024 groundwater hardness at an average of 6.4 grains per gallon. That is moderate, so sediment builds slowly, but it still settles on the tank bottom and makes a gas tank rumble and overheat its base over time. A flush during a repair visit is often worth adding.
The water is disinfected with chloramines. Some rubber washers and seals on drain valves and connectors wear faster under chloramine, which is one reason leaking drain valves are a common call.
Whether the heater sits in a Mesa Verde garage, a College Park laundry closet or a South Coast Metro condo closet, the first checks are the same: gas supply, pilot or igniter, and the thermocouple or flame sensor.
What water heater repair costs
Most repairs are a single part and a visit. These factors change the total.
| Factor | Why it matters |
|---|---|
| The part | A thermocouple or drain valve costs far less than a gas control valve. |
| Fuel type | Gas controls and sealed burners take more labor than electric elements. |
| Pressure issues | Adding an expansion tank or reducing valve adds parts and time. |
| Access | Closet and attic installs are slower than an open garage. |
| Timing | Nights and weekends usually cost more than a scheduled visit. |
Insurance note: policies rarely pay for the repair itself, but may cover sudden water damage from a failed fitting. Take photos before cleanup.
Want your real number? Call (714) 750-8637 and describe the job.
Repairs in Costa Mesa and next door
We repair water heaters across 92626 and 92627 and in nearby cities like Garden Grove. On-demand units have their own service needs, covered on the tankless water heater page.